Logic Is Power


Servo Tester: Box chopped up

A fairly long standing project has been the servo tester for RCMojo, it has all kinds of fancy features, but it’s time to move beyond the breadboard and put it in a project box.

So far so good, the knob controls the servo position, the white button is for mode selection, the slide switch selects vBatt or 3.3v signal, the big hole is a for a ST7565 LCD and the connectors at the top are input and output.

Just got to get that lot onto a board that fits behind the LCD, think I’ll give stripboard a go, failing that I’ll have to break out the UV exposure box!

, , , , , , , , , , ,

Please leave your message after the tone...